top of page
snake stand
back home
how to use /
detach the magnetic cover, upper end, pour in a small amount of any bicycle degreaser, insert bicycle chain through two cut-outs, as shown on the picture, reattach,
align the magnets properly,
hold it with one hand and with the other start pedalling slowly
glass layers /
thicknesses of 2, 3
and 4mm glued with silicone sealant, 4x M5 bolts with square
nuts, there only to give extra weight and protect corners, surfaces on sides polished to translucent and on front a 0,6mm thick UV printed logo.
snake stand
back home
snake-like design /
made out of a single piece of 4 mm thick wall of metal tube,
using no elbows and welding no welds, a continuos snake-like shape
how to use /
simply lift up your bike a bit
and just slide the bike so the needle goes through your sprocket's hole
the two needles /
CNC machined from onewhole piece, full metal, both screwed into stand's ends, rounded off tip so is to not damage, chip paint or skrach your bike's sprocket
needles /
anti-slip coating /
coating has a rubbery feel to it, making it almost
impossible to move/slide when positioned
the sheer weight of such a stand also benifites
to make it harder to tip over
bottom of page